Thanksgiving is eight days out. The house fills up, the oven runs all afternoon, and somewhere around the gravy, the smoke alarm decides to join in.
Below: why your smoke alarm goes off at dinner, a photoelectric alarm worth a look, a door that won't latch, why a full house gets stuffy, browning evergreens, and your TV's movie setting.
Reply and tell us: what sets off your smoke alarm most, the oven, the stovetop or the shower? We read every one.
Why Your Smoke Alarm Goes Off When You Cook

Image: The Home Wire
If your smoke alarm shrieks every time you sear something, the usual culprit is the alarm type and where it hangs. The fix is a photoelectric alarm near the kitchen and the 10-foot rule, and you never pull the battery.
The stakes are real. 59% of US home fire deaths happened in homes with no smoke alarm or one that failed to work, per the NFPA. When alarms failed, a dead or disconnected power source was the most common reason, and the NFPA notes that power sources "are often disabled because of unwanted alarms."
And the top trigger is dinner. In an NFPA-commissioned poll, 73% of people named cooking as what set off their alarm in the past year.
Here's why. An ionization alarm uses a tiny, sealed source of americium to keep a steady flow of charged particles (ions) moving through the air inside it. When smoke breaks that flow, it sounds, per the EPA. That chamber also reacts to water droplets, dust and other aerosols, according to a CPSC report. Steam off a pasta pot counts.
A photoelectric alarm works with light. Smoke scatters light from a small light source onto a sensor, and the CPSC report found these alarms less sensitive to the very small particles behind many false alarms.
TLDR: ionization alarms respond faster to flaming fires, and photoelectric alarms respond faster to smoldering ones. The NFPA calls photoelectric the best type near kitchens and bathrooms, and says alarms should sit at least 10 feet from the stove. The USFA recommends having both types or dual-sensor alarms, so keep what you have and put the right type in the right spot.
To see which kind you own, check the label on the back. It usually names the type.
Here's the routine when it goes off mid-dinner, straight from the USFA:
Open a window or door.
Press the hush button.
Wave a towel at the alarm to clear the air.
If it keeps happening, move the alarm at least 10 feet from the stove.
Leave the battery in. The USFA calls removing it "a deadly mistake."
Renting? Report a badly placed alarm to your landlord in writing, and leave it up in the meantime.
If the one outside your kitchen cries wolf, the pick right below is a photoelectric alarm made for that spot.
Worth a Look
A Photoelectric Alarm Built for the Kitchen Side of the House
The First Alert SM210 10-Year Battery Smoke Alarm is the alarm we'd look at for the hallway outside your kitchen. It's photoelectric, and its battery is sealed in, so there's nothing to pull when the turkey smokes.
Two specs matter this week. The photoelectric sensor uses what First Alert calls Precision Detection, meant to reduce cooking nuisance alarms. And the sealed 10-year battery means no swaps and no low-battery chirps for the life of the alarm.
It has a test/silence button for the hush routine above, sounds at 85 decibels at 10 feet, and is about half the depth of a standard alarm. Target's listing says it meets UL 217 8th Edition, the UL safety standard for smoke alarms.
That said, it's standalone. If the alarms in your home are linked so one sets off the rest, this one won't join that chain. Also note that First Alert's own placement advice is at least 15 feet from cooking appliances, stricter than the NFPA's 10.
It's $29.95 at time of writing. That's First Alert's own store price, and Amazon's may differ, so check the SM210 on Amazon before you buy. We haven't installed one ourselves; the specs here come from First Alert's store and the Amazon listing.
Links in this post may be affiliate links. The Home Wire may earn a small commission if you buy through them, at no extra cost to you.
Why Your Door Stops Latching in Winter

Image: The Home Wire
A door that clicked shut all summer and won't catch in December has a latch that drifted off its strike plate. Find where the latch hits, then move the door or the plate to meet it. Most of the time that takes a screwdriver and a file.
Dry winter air is the usual cause. "When the air is dry, wood loses moisture and shrinks," Purdue Extension explains. Indoor wood swings from about 6% moisture in winter to 12% in summer, according to a National Research Council Canada building digest.
That's why Schlage reads a door that latches in some seasons but not others as a warping door. Houses settle and shift, too. And on older, busy doors, gravity slowly pulls the hinges into a sag, per Bob Vila.
Here's the check, from Family Handyman:
Smear lipstick on the latch.
Stick masking tape over the strike plate.
Close the door so the latch leaves a mark on the tape.
Read the mark. Below the hole means sagging hinges; above it points to the strike plate.
Tighten every hinge screw.
Still missing? Swap one jamb-side hinge screw for a 3-inch screw. The top hinge raises the latch side; the bottom hinge lowers it.
If the latch still lands off the hole, the size of the miss decides the fix:
1/8 inch or less: take the strike plate off and widen its hole with a half-round metal file.
More than 1/8 inch: move the plate. Chisel its mortise (the shallow pocket it sits in) to the new spot, drill new 1/16-inch pilot holes and fill the old ones with wood filler.
Working on a deadbolt? Coat the bolt with chalk instead, and the mark shows you where it hits.
Renting? The lipstick test and tightening loose screws are fair game. Ask your landlord before you file or move the strike plate.
Why a Full House Gets Stuffy
That warm, close feeling by the time the pie comes out is mostly your guests' breath. Crack a window and run an exhaust fan, and the room clears.
Every person at the table breathes out carbon dioxide, or CO2. In a house closed up for winter, it has nowhere to go, so it builds with every guest who walks in.
Outdoors, CO2 sits around 426 ppm, according to NOAA. Ppm means parts per million, so that's 426 molecules of CO2 in every million molecules of air. A crowded living room can run well past that.
CO2 isn't a poison at party levels. A high reading is a sign of stale, shared air, meaning the room isn't swapping enough air with the outside. That's how ASHRAE, the group behind a widely used ventilation standard, reads it. You'll see 1,000 ppm called a limit online. ASHRAE says claims that its standard requires CO2 below a number like that are incorrect.
Can stale air mean foggier thinking? A few small studies point that way. In a 22-person lab study, decision-making scores dropped at 1,000 ppm and fell harder at 2,500. A 24-person Harvard study found scores 15% lower around 945 ppm and 50% lower around 1,400. ASHRAE calls the evidence inconsistent, so treat it as a nudge to air the room out.
Here's the routine, straight from the EPA:
Open a window or a door for a bit when the weather lets you.
Run the kitchen or bathroom fan, as long as it vents outdoors.
Don't lean on the furnace fan. Most home heating and cooling systems don't bring fresh air in, so it just moves the same air around.
Why Evergreens Turn Brown by Spring

Image: The Home Wire
That brown patch on your arborvitae in March is thirst, not cold. The fix starts now: water deeply until the ground freezes, mulch the roots, and screen the windy side with burlap.
Evergreens keep their needles all winter, so they keep transpiring, which means losing water out through the needles. Once the ground freezes, the roots can't pull up more to replace it. That's winter burn, per Penn State Extension and Colorado State's PlantTalk.
Winter sun, wind and big temperature swings keep pulling moisture out. That's why the damage shows up worst on the side facing the sun and wind.
Here's the routine:
Give established shrubs at least 1 inch of water a week into mid or late November, as long as the ground hasn't frozen (UW-Madison Extension).
Give anything planted this year about 2 inches a week.
Spread 1 to 3 inches of mulch over the roots, pulled back from the trunk.
Drive 4- to 5-foot stakes about 2 feet outside the drip line (the outer edge of the branches) on the windy sides, usually south and west.
Attach burlap to the stakes and leave the top open.
Take the screen down in spring, once temperatures stay above 28 F.
Burlap draped over the top sags under snow, Dane County's extension office warns. The farther north you live, the sooner your watering window closes. If a dry spell runs longer than about a month, water again.
Skip the anti-desiccant sprays. The same office calls them "not reliable because they tend to flake off too soon."
Next to a salted walk or road, a freestanding barrier beats wrapping, says the Chicago Botanic Garden. If you do wrap, use burlap only, loosely, with air space.
Renting? Watering and mulch are usually fine. Ask your landlord before you drive stakes.
Why Your TV Makes Movies Look Cheap
If your holiday movie looks like a daytime soap, turn off motion smoothing. For movies, it makes things worse.
Most movies are shot at 24 frames per second, and your TV runs at 60, per LG. Motion smoothing (also called motion interpolation) fills the gap by inventing in-between frames, per RTINGS. The result is the "soap opera effect," film that looks "almost too realistic-looking."
Even Samsung says most movies aren't meant to be viewed with these features on.
The quickest fix is Filmmaker Mode, a picture setting that switches off processing like motion smoothing. LG, Panasonic, TP Vision, Samsung and Vizio have announced support, and it can turn on automatically or with one button or menu, per the Filmmaker Mode FAQ.
Or turn smoothing off by hand:
Samsung: Auto Motion Plus (Picture Clarity), under Settings > Picture > Expert Settings.
LG: TruMotion. Set it to Off, or at least Cinema Motion.
Roku TVs, including TCL and Hisense Roku models: Action Smoothing. Press the Star button, go to Picture settings > Expert settings, and set it to Low or Off (Roku).
Other brands: look under Motion in the picture settings.
Like the smooth look for football? Keep it on for sports. Filmmaker Mode is meant for movies and TV, and other modes suit sports and games.
One quick tap
That's Wednesday: why the smoke alarm goes off at dinner, a photoelectric pick, a door that won't latch, a stuffy house, browning evergreens and your TV's movie setting.
If you only do one thing this week, press hush next time the alarm goes off, and leave the battery in.
Forward this to whoever in your house does the searing.
See you tomorrow.
The Home Wire
This post may contain affiliate links. The Home Wire may earn a commission if you purchase through our links, at no extra cost to you. We only recommend products we believe earn their place in your home.
30 N. Gould St. Suite R Sheridan, WY 82801, United States
